witzig, ich gucke natürlich immer erst bei Watterott, aber diese Platine ist mir in keiner Suche jemals vorgeschlagen worden. Passt natürlich perfekt ...

Pull request for classic firmware:

Since the firmware that I postet in the google group is an untested prototype for users who use an Arduino with CNC shield, it is very likely that thi...

Andrea is right, you need to change the name of the tty port if you use an external Arduino connected via USB instead of the official HAT. You can lis...

did you adjust the stepper motor driver current? If it is really broken, almost any NEMA17 stepper motor will do the job. To make your life easier, yo...

Hi amulaya, does this mean that the GUI does not show or are you saying that you don't know what to do with it? In general, you can find the software ...

Did the scanner work with the previous software version?

Seems as if everything is setup as recommended. We will have a deeper look into this. If you switch back to 0.5.0, will everything work again? We need...

Hi Ralf, thanks for the log. How do you power your device? Best, René

Hi BlastAM, There are 4 workers, because the RaspberryPi has four cores. If more workers will improve the speed needs to be tested, feel free to creat...

We will write a detailed tutorial about the calibration process. Some things need better documentation, but maybe there are also some bugs. We need to...

Hi Erik, thanks for the Feedback. Did you try the wpa_supplicant method? Something like this should work: ctrl_interface=DIR=/var/run/wpa_supplicant...

Den Schaltplan vom Hat findest Du hier:/p> J3 ist der FPC40 Connector, der Dir weiterhelfen könnte... ich habe gerade leider das Datenblatt nicht zur ...

I installed screen on my Pi and was able to test all firmware commands that I was interested in, e.g. turn on/off the laser.