Adam
Adam
@adam
Active Member
Joined: May 31, 2019
Last seen: Jul 11, 2020
Topics: 2 / Replies: 13
Reply
RE: Calibration fails with Fabscan 2020-06-29

Little bit off-topic but any idea why I do not show a mesh-filter (see picture)? Also, 'download' has been misspelled...

4 years ago
Reply
RE: Calibration fails with Fabscan 2020-06-29

@Mario I just installed the fixes that gave me version 0.9.3+202007072202 and indeed I have been able to run the calibration-process. Now doing ju...

4 years ago
Reply
RE: Calibration fails with Fabscan 2020-06-29

I could have tried this too if only I knew where the file to be edited was...

4 years ago
Reply
RE: Calibration fails with Fabscan 2020-06-29

Not here... update and upgrade did not solve the problem.

4 years ago
Reply
RE: Calibration fails with Fabscan 2020-06-29

@mario Yes, one laser. Also, I use the standard calibration pattern. I did a calibartion 3 times, after each new release, all went well, except fo...

4 years ago
Reply
RE: Calibration fails with Fabscan 2020-06-29

@mario No, I cannot make a scan because it tells me the Calibration had failed

4 years ago
Topic
Reply
RE: Calibration Video on Youtube.

Sad to have discovered that the video is no longer available. Does anyone know where to find it right now? Did anyone do a download??

4 years ago
Topic
Replies: 0
Views: 2477
Reply
RE: Camera position

Today I moved my turntable to the highest possible spot on the steppermotor shaft. Bad scans were the results. Then I moved it all the way down until ...

5 years ago
Reply
RE: Camera position

I have been going through that and checking that numerous times. I even 3D printed a stand that fits inside the 'Calibration Mount' and has the top of...

5 years ago
Reply
RE: Camera position

Hello all, Mario, No matter how much I do my best to have my settings for calibration as perfect as can be (like position of the checkerboard paper an...

5 years ago
Reply
RE: my FabScanPi modifications (with pictures)

I did find the 'extender'! Pressing the 'LINK' took me to github! Thanks!

5 years ago
Reply
RE: Server crashes with high settings

The correct command is: sudo service fabscanpi-server restart

5 years ago
Reply
RE: my FabScanPi modifications (with pictures)

Good modifications! I am already considering to do some of them to my fabscan! Can you give me a link to your: fabscanpi-extender ? I cannot find it ...

5 years ago