Ciclop support. - [Software/Hardware] Development https://fabscan.org/community/development/fabscan-server-and-ciclop-support/ FabScan Discussion Board en-US Thu, 13 Aug 2026 00:02:53 +0000 wpForo 60 RE: Ciclop support. https://fabscan.org/community/development/fabscan-server-and-ciclop-support/#post-328 Fri, 30 Aug 2019 00:55:54 +0000 Assuming that since the /develop tree with 2 laser support hasnt moved over to the release tree, that it's still a work in progress.  Happy to test whenever you say it's ready.

]]> [Software/Hardware] Development ewr2san https://fabscan.org/community/development/fabscan-server-and-ciclop-support/#post-328 Ciclop support. https://fabscan.org/community/development/fabscan-server-and-ciclop-support/#post-317 Fri, 09 Aug 2019 06:10:47 +0000 Things are almost done. I have tested a hardware setup which works. The server can be configured to use the ciclop hardware setup, even the original Arduino board (aka ZUM shield) can be used. 

The cilcop support is part of the release for the second laser. All things will be within v.0.8.0 (planed release date is mid. of august 2019)

14

The board is powered by a 12v Power supply. A step-down circuit is used to provide the needed 5V power to the Raspberry Pi.

13

Raspberry Pi and Ciclop are both mounted on a wooden plate. 

11

12

Do not expect too much. This will be a first version which works but there might be still bugs. 

]]> [Software/Hardware] Development mario https://fabscan.org/community/development/fabscan-server-and-ciclop-support/#post-317