problem with calibration - [Software] FabScanPi Server

RE: problem with calibration

Danilo0702 — Mon, 18 Mar 2019 16:52:06 +0000

yes, everything is ok. But i have 5 logfiles in the folder.

RE: problem with calibration

AndreaCH — Mon, 18 Mar 2019 15:20:48 +0000

Danilo0702, have you tried to look at the file /var/log/fabscanpi/fabscanpi.log?

RE: problem with calibration

Danilo0702 — Mon, 18 Mar 2019 12:47:11 +0000

I do not know what's wrong

RE: problem with calibration

AndreaCH — Mon, 18 Mar 2019 12:15:04 +0000

Danilo0702,
at the end of the meshing a small signal appears at the top left that disappears immediately, so it can escape the view. When it is finished you see another tab on the left, to the right of the point cloud. (Or from the system shell the meslab-server process is no longer executed).
Andrea

RE: problem with calibration

Danilo0702 — Mon, 18 Mar 2019 11:46:27 +0000

I have a scanned file and I open the bottom right. I choose output format ---- stl (obj), and the meshing process starts. But nothing is displayed. Even after several hours not when I'm waiting

RE: problem with calibration

AndreaCH — Mon, 18 Mar 2019 11:29:07 +0000

Hi Danilo0702,
I have a bit of trouble too, so I can't get the scans done correctly, I'm investigating. The laser beam must be perfectly vertical and must pass through the center of the plate. The superimposed vertical line of the camera must pass through the center of the plate. The calibration table with the white and black checkerboard must be placed in front of the camera. The lid of the container must be closed. The calibration takes about 10 minutes or less. Mesh creation can be done when you open the saved scan, on the right you see icons including the one that allows you to execute the mesh where you can select the output file format, even directly STL to be able to print it.
Andrea

problem with calibration

Danilo0702 — Mon, 18 Mar 2019 10:00:16 +0000

Hey, I set up my Fabscan and it works. The biggest problem is calibrating. What do I have to do? I can not find instructions. The laser must be vertical or inclined on the chessboard-pattern? I get the message, the calibration was ok, but the subsequent scan just looks like a bullet. Also the Fabscan does not meshed in another format after scan. I will wait many hours but nothing --- only one .ply file. I hope everyone can help.