Notifications
Clear all

Test scans with Ciclop & FabScan  

  RSS
aduda
(@aduda)
Active Member

Thank you for all the work which went into FabScan. I used it to modify an old Ciclop and replaced the USB camera with a Raspberry + Camera V2 running the FabScan image. The calibration was a bit challenging, but the scans look pretty impressive for the setup. I think there is even room for improvements like simplifying the calibration or speeding up the scans by at least 10x without compromising quality ?. If I find some time I will definitely have a closer look.

In case these improvements are of interest for someone I can share it here.

Bildschirmfoto 2020 01 20 um 12.31.37
Bildschirmfoto 2020 01 20 um 19.35.51
Bildschirmfoto 2020 01 20 um 12.56.02
Bildschirmfoto 2020 01 20 um 19.14.52
Bildschirmfoto 2020 01 20 um 14.42.42
Bildschirmfoto 2020 01 20 um 11.03.36
Bildschirmfoto 2020 01 20 um 19.31.31
overview

 

Quote
Posted : 20/01/2020 7:52 pm
mario liked
mario
(@mario)
Member Admin
Posted by: @aduda

The calibration was a bit challenging, but the scans look pretty impressive for the setup. I think there is even room for improvements like simplifying the calibration or speeding up the scans by at least 10x without compromising quality ?. If I find some time I will definitely have a closer look.

In case these improvements are of interest for someone I can share it here.

Thank you for sharing this. I created a new topic for discussing possible improvements....

ReplyQuote
Posted : 22/01/2020 7:06 am
aduda
(@aduda)
Active Member

@mario I wanted to write you personally but this forum has no private messaging ... 

I am bit puzzled why my last post about a new software project tremandously pushing the performance of FabScan scanners for the community is not allowed on this community form. I hope it is just an error that the post was silently closed before being visible to anyone.

My understanding is that FabScan is for makers sharing his/her new solutions with others to make expensive technologies available to anyone.

Thanks for any clarifications.
Alex

ReplyQuote
Posted : 18/04/2020 8:35 pm
mario
(@mario)
Member Admin

@aduda sure just send me a mail.

ReplyQuote
Posted : 23/04/2020 3:24 pm
Share: