Little bit off-topic but any idea why I do not show a mesh-filter (see picture)? Also, 'download' has been misspelled...

@Mario I just installed the fixes that gave me version 0.9.3+202007072202 and indeed I have been able to run the calibration-process. Now doing ju...

I could have tried this too if only I knew where the file to be edited was...

Not here... update and upgrade did not solve the problem.

@mario Yes, one laser. Also, I use the standard calibration pattern. I did a calibartion 3 times, after each new release, all went well, except fo...

@mario No, I cannot make a scan because it tells me the Calibration had failed

Sad to have discovered that the video is no longer available. Does anyone know where to find it right now? Did anyone do a download??

Today I moved my turntable to the highest possible spot on the steppermotor shaft. Bad scans were the results. Then I moved it all the way down until ...

I have been going through that and checking that numerous times. I even 3D printed a stand that fits inside the 'Calibration Mount' and has the top of...

Hello all, Mario, No matter how much I do my best to have my settings for calibration as perfect as can be (like position of the checkerboard paper an...

I did find the 'extender'! Pressing the 'LINK' took me to github! Thanks!

The correct command is: sudo service fabscanpi-server restart

Good modifications! I am already considering to do some of them to my fabscan! Can you give me a link to your: fabscanpi-extender ? I cannot find it ...