Firstly, many thanks to the team for all the hard work!
Newly built Fabscan Pi,
Calibration OK
Scan starts, operates for one full revolution of the turntable, then hangs, and server becomes unresponsive.
Only apparently relevant log entries (repeated many times)
<<2020-08-17 13:40:45,368 [555:1577178208] WARNING - fabscan.server.services.api.FSStreamHandler: Error while trying to trigger the scan processor: local variable 'jpeg' referenced before assignment
2020-08-17 13:40:45,368 [555:1577178208] WARNING - fabscan.server.services.api.FSStreamHandler: Stream canceled....
followed by:
2020-08-17 13:17:40,209 [563:1995721424] DEBUG - fabscan.scanner.interfaces: Scanner Type is: laserscanner
2020-08-17 13:17:42,375 [563:1995721424] DEBUG - fabscan.scanner.laserscanner.driver.FSSerial: Port in Config found
2020-08-17 13:17:42,381 [563:1995721424] DEBUG - fabscan.scanner.laserscanner.driver.FSSerial: Latest available firmware version is: v.20200624
2020-08-17 13:17:44,733 [563:1995721424] INFO - fabscan.lib.util.FSUtil: b'avrdude-original: Using autoreset DTR on GPIO Pin 7'
2020-08-17 13:17:45,303 [563:1995721424] DEBUG - fabscan.scanner.laserscanner.driver.FSSerial: Trying to connect Arduino on port: /dev/ttyAMA0 >>
It is entirely possible that I have missed something in the setup because
a) This is out of my normal field of computing
b) I am pleasantly fuzzy due to opiates following surgery last week
Any assistance would be appreciated
use not 100% resolusion and not color and not automatic -- both mayby 25% .... There are a issue in this version.
