Hy I just built my Fabscan Pi and calibration ends fine without any error. But when I want to do a scan I get the message that the scanner isn't calibratied and I can't use it. Can anyone help me with this. Tried several times. Always same problem.
please more info - which version do you have?
Server: v.0.9.4
Firmware: v.20200624
I mean, exactly this problem with the v0.9.4 was discussed here recently (for 1-2 weeks ago) in ((I think)) the German forum and that a solution has been found.
OK, I will have to search again than. Didn't find anything on this problem :-( Thanxs
Are you using one or two lasers? If you are using only a single laser, you need to adjust the number of lasers value form 2 to 1 in the config file. Restart the server and do another calibration.
