FabscannerSmith
FabscannerSmith
@fabscannersmith
Active Member
Joined: Mar 15, 2019
Last seen: May 6, 2019
Topics: 2 / Replies: 7
Topic
Replies: 5
Views: 4389
Reply
RE: Problems with first Callibration

So thanks a lot for the help. Now it works, but it wasn´t one problem alone. So first of all i checked all solder joints. They were good, so i decided...

5 years ago
Reply
RE: Problems with first Callibration

Hey guys, Its been a while, but i did not get to manage this thing. I couldn`t get a callibration for the scanner. The scanner hangs up after the firs...

5 years ago
Reply
RE: Current HAT wiring.

Hello Mario, thanks for the new wiring diagramm. I followed you instructions with this. I`ve bought a Watterot Set one year ago. I have an 17HM3410 nr...

5 years ago
Reply
RE: Connecting stepper motor 17HM3410 nr 20170821 to FabScanPi Hat

So I bought the same set from Watterrot with the same motor, so i decided to follow your instructions, and cable the board as you showed on the pictur...

5 years ago
Reply
RE: Problems with first Callibration

There wen something wrong with the picture so here is it again:

5 years ago
Reply
RE: Problems with first Callibration

Hello, I get no good results after a few recallibration. The Fabscan shows that the callibration worked and i`ve followed the instructions of AndreaCH...

5 years ago
Reply
RE: Problems with first Callibration

Yeah, the Problem was that after calibration the whole Pi did not react anymore and if I wanted to reload the Online User Interface it sayd that the U...

5 years ago
Topic
Replies: 11
Views: 2996