This user account status is Approved

Forum Replies Created

RE: New Frontend.

Hi Mario,I look forward to the new version with the new frontend; the current version gives me some problems because it always puts the client's graphic GPU at 100% and I think that part of the blocki...

In forum [Software/Hardware] Development

5 years ago
RE: Rpi Firmware

Posted by: amulaya I'm using an arduino uno with cnc shield in place of hat. I had asked about it in the google group. if you have connected arduino <-> raspberry via USB, you can try /dev/tt...

In forum [Hardware] Electronics

5 years ago
RE: Rpi Firmware

2019-03-19 11:56:26,727 - fabscan.scanner.laserscanner.driver.FSSerial - ERROR - No FabScanPi HAT or compatible device found on port /dev/ttyAMA02019-03-19 11:56:26,727 - fabscan.scanner.laserscanner....

In forum [Hardware] Electronics

5 years ago
RE: Rpi Firmware

Can you ping fabscanpi ip address from your PC?

In forum [Hardware] Electronics

5 years ago
RE: problem with calibration

Danilo0702, have you tried to look at the file /var/log/fabscanpi/fabscanpi.log?

In forum [Software] FabScanPi Server

5 years ago
RE: Rpi Firmware

Hi Amulaya,I also tried starting from a Raspbian-lite image, but I encountered problems in particular with the python-opencv-tbb package that I didn't understand where to find it.Try instead to create...

In forum [Hardware] Electronics

5 years ago
RE: problem with calibration

Danilo0702,at the end of the meshing a small signal appears at the top left that disappears immediately, so it can escape the view. When it is finished you see another tab on the left, to the right of...

In forum [Software] FabScanPi Server

5 years ago
RE: problem with calibration

Hi Danilo0702,I have a bit of trouble too, so I can't get the scans done correctly, I'm investigating. The laser beam must be perfectly vertical and must pass through the center of the plate. The supe...

In forum [Software] FabScanPi Server

5 years ago
RE: Communicate with FabscanPI HAT

Thank you all,I tried to call the minicom program as root, indicating the command line parameters root@fabscanpi:/home/pi#root@fabscanpi:/home/pi# /etc/init.d/fabscanpi-server stopfabscanpi-server st...

In forum [Software] FabScanPi Server

5 years ago
Communicate with FabscanPI HAT

Hello,is it possible to talk from Raspberry PI with the FabscanPI HAT card via (internal connected) serial to perform tests? I see in the configuration that Raspberry PI uses the device /dev/ttyAMA0, ...

In forum [Software] FabScanPi Server

5 years ago