...tried this way, no success: but as I mentioned in my first post, the cal-board comes on the screen for about 5 squares high, cal-process starts and announces 12 minutes left, but halfway (6 minutes...

Thanks for the info, Mario. I've got a model 2 like this, but using the cam doesn't look towards the center of the table at all. Not a matter of a just a few degrees, as it's looking straight towards ...

(continued II) The calibration log file looks Ok and so does the default.config.json file with the calibration values. I include them here ! {"folders": {"www": "/usr/share/fabscanpi/","scans": "/home...

(continued) I only get uncoherent scan results. See pics of vertical aligned laser going through center of turntable, spring-adjustable cam-module from standard predrilled holes position so that vert...

Looking forward to the tuto! But maybe you could give us a quick hint, there, about where to point the camera crosshair ?? I only get uncoherent scan results. < span style="color: #666;"> Attachment ...

The stepper motor delivered with my kit is 17HM3410 nr 20170821Watterott is selling this 400 Steps/Rev motor and by downloading the data sheet for 17HM3410 stepper motors and got the right color wirin...

Why would you want to change the rotation parameter from true to false Smassard?

Related question here... - No problem to align the laser vertically against the backplate and going through the center of the turntable, but I'm reading contradictory comments so can't figure out: * i...

Hi René that's what I did, but I didn't realize I had to write the wpa_supplicant.conf file to a freshly imaged SD-card. I had first tested the 0.7.0 release via my ethernet connection, then put back ...

Hello and thank you for this update. Have been struggling to get the wifi working but finally managed to do so (I'd better share my remarks about this in a seperate post) Discovering the FabScanPi thr...