Liked Forum Posts
|
RE: Configuration for 400 step Motor Yes, I just tested it. Under the driver there are three of these jumper pads, label C3, C2, and C1. First I verified which of them are connected to MS1 and MS2. It are C1 and C2. I soldered the midpad... |
In forum Hardware |
4 years ago |
|
RE: Configuration for 400 step Motor Attachment : CIMG0707.JPG |
In forum Hardware |
4 years ago |
|
RE: fabscan.scanner.laserscanner.driver.FSSerial - ERROR - No FabScanPi HAT or compatible device found on port /dev/ttyAMA0 Hi @mario, I have the same configuration, image version and fabscanpi.log as @CheSeb. I have tried (last week) to flash the bootloader to the HAT using the raspberry pi and then an Arduino Uno, withou... |
In forum [Hardware] Electronics |
4 years ago |
