rene
rene
@rene
Admin
Active Member
Joined: Feb 21, 2019
Last seen: Apr 23, 2020
Topics: 0 / Replies: 14
Reply
RE: RPi-Fabscan-Hat

witzig, ich gucke natürlich immer erst bei Watterott, aber diese Platine ist mir in keiner Suche jemals vorgeschlagen worden. Passt natürlich perfekt ...

6 years ago
Reply
RE: Rpi Firmware

Pull request for classic firmware:

6 years ago
Reply
RE: Rpi Firmware

Since the firmware that I postet in the google group is an untested prototype for users who use an Arduino with CNC shield, it is very likely that thi...

6 years ago
Reply
RE: Rpi Firmware

Andrea is right, you need to change the name of the tty port if you use an external Arduino connected via USB instead of the official HAT. You can lis...

6 years ago
Reply
RE: Stepmotor is broken

did you adjust the stepper motor driver current? If it is really broken, almost any NEMA17 stepper motor will do the job. To make your life easier, yo...

6 years ago
Reply
RE: Rpi Firmware

Hi amulaya, does this mean that the GUI does not show or are you saying that you don't know what to do with it? In general, you can find the software ...

6 years ago
Reply
RE: Scanning Issues

Did the scanner work with the previous software version?

6 years ago
Reply
RE: Software Release v.0.7.0

Seems as if everything is setup as recommended. We will have a deeper look into this. If you switch back to 0.5.0, will everything work again? We need...

6 years ago
Reply
RE: Software Release v.0.7.0

Hi Ralf, thanks for the log. How do you power your device? Best, René

6 years ago
Reply
RE: Increase Speed FabScanPi

Hi BlastAM, There are 4 workers, because the RaspberryPi has four cores. If more workers will improve the speed needs to be tested, feel free to creat...

6 years ago
Reply
RE: Camera position

We will write a detailed tutorial about the calibration process. Some things need better documentation, but maybe there are also some bugs. We need to...

6 years ago
Reply
RE: Software Release v.0.7.0

Hi Erik, thanks for the Feedback. Did you try the wpa_supplicant method? Something like this should work: ctrl_interface=DIR=/var/run/wpa_supplicant...

6 years ago
Reply
RE: RPi-Fabscan-Hat

Den Schaltplan vom Hat findest Du hier:/p> J3 ist der FPC40 Connector, der Dir weiterhelfen könnte... ich habe gerade leider das Datenblatt nicht zur ...

6 years ago
Reply
RE: Communicate with FabscanPI HAT

I installed screen on my Pi and was able to test all firmware commands that I was interested in, e.g. turn on/off the laser.

6 years ago