I have some ideas, but I need to do some tests.

Hey guys, this thread seems to be very interesting... it just seems to be because if it was written in English more people could contribute... Thanks, Iade Gesso, PhD

Reading permissions should be enough for downloading and browsing the files in the filesystem. It should be possible to download the files with reading permissions only. However it sounds like a bug. ...

@rene ich hab da noch was besseres gefunden und noch dazu zu einem echt fairen Preis. GPIO Adapter für RPi-Display B+ Ihr habt doch Kontakt zu Watterott, ihr könntet denen doch mal Bescheid geben, das...

< span style="color: #666;"> Attachment : Front.jpg < span style="color: #666;"> Attachment : Bottom.jpg

I have to agree with Mario, black is the best (but only matte black).I have covered the inside with matte black adhesive foil (from the hardware store) and provided with a narrow strip of orange paper...

2nd Scan , I have tried ./api/v1/log/downLoad/ But I just get 404 < span style="color: #666;"> Attachment : Scan2a.pdf

Please prove the solder joints of the motor driver and of the pin headers on the FabScan Pi HAT again. I would recommend to resolder them. Some on the picture above look as there are cold solder joint...

Hello Mario, thanks for the new wiring diagramm. I followed you instructions with this. I`ve bought a Watterot Set one year ago. I have an 17HM3410 nr 20170821 motor and the problem is that the callib...

I think black is the better option, because white can cause reflections what actually might disturb the laser recognition. The object scan process is performed in total darkness, that is the reason wh...

I don't think that your motor is broken. The motors are really robust. As Rene mentioned check the motor current settings. The reference voltage should be between 0.7 and 0.8 volts (with this the moto...

did you adjust the stepper motor driver current? If it is really broken, almost any NEMA17 stepper motor will do the job. To make your life easier, you should get a motor with 400 steps per revolution...

So I bought the same set from Watterrot with the same motor, so i decided to follow your instructions, and cable the board as you showed on the picture. The problem is now, that the callibration did n...

Thank you for the suggestion. The camera module is delivered with a little white plastic tool since a while. This can be used to adjust the camera sharpness. < span style="color: #666;"> Attachmen...

Hello, the holes in the case are aligned in a way that the cam should exactly match the center of the table. One thing i realised in the last two years is that not all lenses are glued perfectly onto...

We will write a detailed tutorial about the calibration process. Some things need better documentation, but maybe there are also some bugs. We need to take some time for further investigation. If thin...

Danilo0702,at the end of the meshing a small signal appears at the top left that disappears immediately, so it can escape the view. When it is finished you see another tab on the left, to the right of...

Hi Danilo0702,I have a bit of trouble too, so I can't get the scans done correctly, I'm investigating. The laser beam must be perfectly vertical and must pass through the center of the plate. The supe...